|
|
|
 when things start to get a little stressful, "FIRST: Fun Is Required. So Tolerate!" - Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| when things start to get a little stressful, "FIRST: Fun Is Required. So Tolerate!" - Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
window motor spec sheet confusion
I'm designing the final stage of the articulation of our arm and we have choosen to use the window motor
<http://www2.usfirst.org/2004comp/Specs/Nippon-Denso_Window_Motor_specs.doc> However, where the sheet mentions the specs for the output gear, they list 12-14 as the diamatral pitch. Why are there two pitches??? Which one should we use when we order gears to mesh with that gear? Have any teams used one/or the other with any success? Are we allowed to remove the output plate and press on our own gear? Thank you in advance! Good luck this year! -Andy |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| window motor solid model | Redhead Jokes | Inventor | 0 | 04-02-2003 14:23 |
| sheet rubber | Adams High Man | OCCRA | 1 | 20-10-2002 10:07 |
| Looking for window kit parts | archiver | 2000 | 2 | 23-06-2002 22:50 |
| Re: window motors | archiver | 1999 | 1 | 23-06-2002 21:56 |
Threaded Mode