Go to Post Our opponents didn't know where our robot was going and neither did we! - ReapersRule [more]
Home
Go Back   Chief Delphi > Technical > Technical Discussion
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #4   Spotlight this post!  
Unread 29-01-2004, 21:02
Rickertsen2 Rickertsen2 is offline
Umm Errr...
None #1139 (Chamblee Gear Grinders)
Team Role: Alumni
 
Join Date: Dec 2002
Rookie Year: 2002
Location: ATL
Posts: 1,421
Rickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant futureRickertsen2 has a brilliant future
Send a message via AIM to Rickertsen2 Send a message via Yahoo to Rickertsen2
Re: Removing Drill pinion

Quote:
Originally Posted by SarahB
This thread has lots of information about how to do so the right way. Basically, use an Arbor press to remove it, but don't, under any circumstances, try the Dremel technique. We've already had to replace two motors because of it.
Ok, I still don't get how i am supposed to fit a plate between the pinion and the drill body. Do i dremel out a space to put a plate, and then press it off?

Funny but stupid idea:
1.) Put the whole motor in a lathe chuck.
2.) Somehow lock the chuck from spinning.
3.) apply power to the motor
4.) slowly lathe the gear down to a peice of foil and slide it off.

or you could stuck some assorded stuff into the motor to jam the rotors and use the lathe as normal. Please don't try either of these things.

Seriously though, we need some help here.
__________________
1139 Alumni
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Coupling the drill motor with out the 15 tooth gear Chopper_Dave Motors 1 17-01-2004 01:06
Portable cordless drill press Gui Cavalcanti Technical Discussion 25 03-08-2003 22:21
drill motor mounts- again Jeff Sharpe Motors 6 07-04-2003 23:20
Emergency drill trade/sell Anarkissed General Forum 3 16-02-2003 22:37
"Motors and Drive train edition" of Fresh From the Forum Ken Leung CD Forum Support 6 29-01-2002 12:32


All times are GMT -5. The time now is 21:18.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi