|
|
|
 Okay, who's willing to admit they treat their robot as a pet? - Bill Moore [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Okay, who's willing to admit they treat their robot as a pet? - Bill Moore [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Who's Drilled the Most Lightening Holes?
Heh, let's see who's got the most in ONE COMPONENT, please.
I was a member of our team's "Hail Mary" device (extendable arm to reach the endzone). We had so many holes to drill it wasn't funny. We had 12 peices in our part. Counting each side, that's 24 sides to drill in. We had 3 holes for attaching per peice. We had 83 holes on each side of each peice. 24 * 83 + (3 * 24) = 2064 holes. All drilled and deburred. Oh, and we had to make two sets of them, too. Wheee! And FYI, overall weight loss on the peice was 1lb. Divide that by the number of holes, and we get.... a whopping total of 4.844 x e-4 lbs lost per hole. Can anyone share in our misery?  
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Making a series of spaced holes around a cylinder in inventor | James114 | Inventor | 13 | 21-11-2004 18:44 |
| Machine weight and holes | archiver | 2000 | 0 | 23-06-2002 22:51 |
| Go Home Device Advice? | Eric Reed | Technical Discussion | 8 | 18-03-2002 08:14 |
| Tapped Drill motor holes: thread anyone? | joe_balint | Motors | 2 | 16-01-2002 08:40 |
| Drill holes | nick reynolds | Rumor Mill | 10 | 12-01-2002 01:39 |
Threaded Mode