|
|
|
 dont be afraid of new technology. embrace it and experment with it figure out the problems on the way and then tell us about it so it gets easier. - Tytus Gerrish [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| dont be afraid of new technology. embrace it and experment with it figure out the problems on the way and then tell us about it so it gets easier. - Tytus Gerrish [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
04-02-2004, 20:59
|
|||
|
|||
|
Re: Cannot place constrain in Inventor
The way by creating a component off of the motor sounds like a good idea. Haven't tried it yet but I will. Thanks.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 12 in. Wheel in Inventor 7 | petek | Inventor | 1 | 17-01-2004 17:53 |
| Inventor for Ventures? | Jeff Waegelin | CD Forum Support | 5 | 03-04-2003 12:33 |
| Help with Inventor Assembling | AJ Quick | Inventor | 4 | 18-01-2003 09:45 |
| Competition at UTC New England | Rick Gibbs | Regional Competitions | 6 | 02-04-2002 09:25 |
| Inventor and Virtual Kit of Parts | Torchin | Inventor | 1 | 09-01-2002 09:59 |
Threaded Mode