Burning IR sensors - Chief Delphi

05-02-2004, 16:06

LittleProton LittleProton is offline

Skinflute Player

AKA: Joe Gannon

#1388 (Eagle Robotics)

Join Date: Oct 2003

Location: Arroyo Grande, CA

Posts: 2

LittleProton is an unknown quantity at this point

Burning IR sensors

The IR sensors provided with the kit of parts seem to fry easily. So far the only heat I’ve applied to the sensors is soldering and the +5v from the controller. Is this a problem for any other teams? Any advice/help would be appreciated.

__________________
"The best thing about that is, I wanted it to happen and then it did!" Black Mage
8BTH

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
wiring diagram for light sensors???	pagemauck	Control System	1	21-01-2004 16:32
what type of sensors are good and convenient	magical hands	Programming	7	04-01-2004 23:04
PWM and burning out motors	patrickrd	Technical Discussion	7	19-06-2003 15:30
Robotics Tournament at Sensors Expo & Conference	Kyle Fenton	Off-Season Events	4	04-05-2003 12:15
Robogui ! sensors don't work	Fares	Programming	2	07-01-2003 16:31

All times are GMT -5. The time now is 20:32.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.