|
|
|
 HOLY MOLY CANOLI THIS LOOKS LEGIT - MasterEric [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| HOLY MOLY CANOLI THIS LOOKS LEGIT - MasterEric [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
06-02-2004, 17:39
|
||||
|
||||
|
Re: Drill RPM
its in the spec sheet section of the documents at the FIRST website. I believet they are all zipped together in one big file, but its in there - graphs and everything
|
|
#3
06-02-2004, 21:00
|
|||||
|
|||||
|
Re: Drill RPM
for forward and reverse numbers and a general discussion about the differences, check this thread:
http://www.chiefdelphi.com/forums/sh...threadid=23845 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Automatic Transmission" | Madison | Technical Discussion | 70 | 24-11-2003 09:03 |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| Emergency drill trade/sell | Anarkissed | General Forum | 3 | 16-02-2003 22:37 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Linear Mode
