1/2" #20 threads keyless chuck needed

As far as we know, FIRST could replace football by 2018! - Adam Richards [more]

		Chief Delphi > Technical > Motors
1/2" #20 threads keyless chuck needed

Thread Tools

Rate Thread

Display Modes

02-12-2004, 09:40 PM

Jeff Frangenber Jeff Frangenber is offline

Registered User

#0836

Join Date: Feb 2004

Location: St. Mary's County MD

Posts: 1

Jeff Frangenber is an unknown quantity at this point

1/2" #20 threads keyless chuck needed

We need to find a drill chuck to go onto the Bosch drill motor head (1/2" #20 - 20 threads per inch). Can anyone tell me where we can get one on short notice?

Also can anyone tell me if it is legal to use a drill chuck?

We tried to connect a 1/4 flexible shaft to the Bosch drill motor head with a set screw but it is tearing up the flexible shaft and not holding. We are hoping a drill chuck will do the trick.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:00 AM.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.