|
Field Tolerances
Forgive me if this has been discussed elsewhere (I searched "tolerance" and did not find this topic) but I just read in the manual (I believe it is section 3.1.1) that field dimensions are + or - 1 inch!
Does this mean that the step has the possiblity of being 7 inches high? They say they will try to get it as close as reasonably possible but a 1 inch difference over 6 inches is a lot. What is the maximum amount higher it is likely to be?
Thanks.
__________________
Teacher/Engineer/Machinist - Team 696 Circuit Breakers, 2011 - Present
Mentor/Engineer/Machinist, Team 968 RAWC, 2007-2010
Technical Mentor, Team 696 Circuit Breakers, 2005-2007
Student Mechanical Leader and Driver, Team 696 Circuit Breakers, 2002-2004
|
..this is the first robot we've built that succeeded at everything we wanted it to. It was simple. It was low maintenance. It scored effectively. It had an autonomous that worked. Its look caught attention. And it was finished on schedule. - Donut [more] 
Similar Threads
Threaded Mode