|
|
|
 We need to start building FIRST competition arenas and leasing them in the off-season to the sports teams and conventions ;) - protoserge [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| We need to start building FIRST competition arenas and leasing them in the off-season to the sports teams and conventions ;) - protoserge [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
pic: 1067's amazing finish
|
|
#3
15-02-2004, 14:18
|
||||
|
||||
|
Re: pic: 1067's amazing finish
Quote:
Thank you. That plate took me about 45 seconds- a minute to finish. And the best part: Its just normal aluminum. So no extra material required, just do that to your structural stuff That plate took me about 45 seconds to do. Last edited by Frank(Aflak) : 15-02-2004 at 15:24. |
|
#4
15-02-2004, 19:14
|
||||
|
||||
|
Re: pic: 1067's amazing finish
I think it would look cool with an anodize on it. It would prevent it from tarnishing and you could chose either a clear or a color for it. The downside to a color is if it gets scratched it would look bad, but them again your robot could show off it's "battle scars".
|
|
#5
15-02-2004, 20:00
|
|||||
|
|||||
|
Re: pic: 1067's amazing finish
http://www.chiefdelphi.com/forums/at...achmentid=1576
Been there done that... Was wickedly cool!!! We did that in 2002. This was our configuration for our winning NYC regional! We painted the side panel PPG Orange Candy Coat with lots of clearcoat! |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TCP/IP on a PIC | Venkatesh | Electrical | 1 | 18-11-2003 21:00 |
| pic: Another pic of Team 930 | CD47-Bot | Robot Showcase | 7 | 25-02-2003 21:07 |
)
Linear Mode
