|
|
|
 A lot of people posting without first hand knowledge, that's fun. - Aren_Hill [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A lot of people posting without first hand knowledge, that's fun. - Aren_Hill [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
|
Gear Experts Only
Last week I posted a question and got no response so I'm going to try one last time. So now that I've got you attention:
Does anybody know what the tooth profile is on the final gear in the Fisher-Price gearbox?. The best I can measure the pitch is 14. But what is the pressure angle? It looks to be more than 20deg. The first person with a correct response will recieve, absolutely free, a custom encoder gear to use as you see fit. Correctness will be determined by the mesh of a fabricated gear with the FP gear. Partial credit if you can tell me how to figure out what the pressure angle is with a pair of calipers and not much else. ChrisH |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thunder Chicken CCT | Simon G | Motors | 4 | 03-01-2003 13:18 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drivetrain help | thedillybar | Technical Discussion | 9 | 08-01-2002 21:54 |
| Drivetrain Help | Jordan | Technical Discussion | 16 | 02-12-2001 12:14 |
| Drill motor gearBox question | Dennis Hughes | Motors | 4 | 11-10-2001 07:11 |
Threaded Mode