Robot Collaboration

[Matt Adams]

My one and only qualm is about how this will work with the $3,500 limit.

1. There has obviously been some machining done by other teams.

2. This machining needs to be billed out at a reasonable cost.

I don't see how it can be honestly billed out at a reasonable rate to both teams, and stay within the $3,500 limit.


If it can be done within the rules, I'm all for it.

However, simple algebra says that any reasonable amount of outside machining time at a reasonable (or even very generous) rate will add up to tens of thousands of dollars very quickly.

I don't see how it can be done, but I sincerely hope that I'll be proved wrong. I hate to say it, but I think we're going to need an official ruling on this from FIRST. I'd assume that someone from one of the teams has already asked FIRST about it before venturing too far.

What ruling did they give you?

If you haven't asked... I propose this goes up on the Q&A in section 5.3

Good luck everyone!

Matt