Inconsistant Joystick

[bstempi]

Originally Posted by Astronouth7303

Are you using basicly the default code? Or did you rewrite the Default_Routine? Check below the pwm assignments, and comment out the stuff with pwm04. I had the same problem, and that fixed it. I think its limit switches, but I can't remember.

Truth, when I did that, it worked. That was the only time it worked. After that, it went back to behaving as before, but I'll be sure to double check it. It's possible that someone changed the code without my knowing. Other than the limit switch default stuff, pwm04 isn't used anywhere else. Just out of curiosity, should the limit switch stuff matter? I browsed through it and haven't taken the time to pick it apart, but I thought the default was set so that a certain set of pwms didn't operate is a digital input was set to 1. Thank you both for your input.
~Bstempi