|
|
|
 Sorry, solenoids don't speak English.
You can talk at them, but they won't answer except maybe to sigh... - Mark McLeod [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Sorry, solenoids don't speak English.
You can talk at them, but they won't answer except maybe to sigh... - Mark McLeod [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Program machine to turn and stop
Our team needs help with programming. We would like to speed our robot forward (dead reckonning) and have the IR sensor mounted on the servo detect say 45degrees. At 45 degress the robot would turn towards the balls and coast to a stop as it crashes into the tee balls knocking one or both balls off the tee.
I dont know it this is hard or easy as we are short on the programming end of things on our team. Thanks in advance |
|
#2
19-02-2004, 12:50
|
||||
|
||||
|
Re: Program machine to turn and stop
have you tried the code on www.kevin.org/frc yet?
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HYPER Minimeet/PracticeDay UPDATE | ChrisC | Off-Season Events | 0 | 14-02-2004 11:49 |
| how to add steps in the provided encoder program for the edu | Zaramel2002 | Programming | 3 | 11-02-2004 08:35 |
| Here Is A Rapid Update From Team Hyper MINI-MEET 2003 | CMC | Off-Season Events | 1 | 13-02-2003 18:54 |
Linear Mode
