|
|
|
 I was dragged to the first team meeting in September my freshman year and a week later, found myself at Fall Classic. Needless to say, after experiencing the heat of a competition, I was in love. ... Robotics has become far more than just that. I get to do the coolest thing in the world. - Audrey Chu [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Victors for Chips Cutting Off
I posted a question in the motors section of the forums about the dimensions of the clutch spring earlier, now we have found that rather than a mechanical problem we are having an electrical/control system problem. We are having problems with the Victors going to the Chips cutting off at 9 volts. The Victors for the Drills and the Chips are running on the same PWM cable (one of the Y-cables supplied with the kit) Both of our chips (atwoods) are doing this. Does anyone have any suggestions as to why this is happening?
Thanks, Aaron |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| In need of victors | Big H | Kit & Additional Hardware | 1 | 18-02-2004 20:35 |
| Cutting the output shaft | Kevin A | Technical Discussion | 2 | 18-02-2003 01:47 |
| victors | great_one411 | Electrical | 4 | 06-02-2003 09:08 |
| Flakey Victors | archiver | 1999 | 4 | 23-06-2002 21:58 |
| DON'T Recalibrate Victors! | Joe Johnson | Off-Season Events | 0 | 12-11-2001 22:58 |
Threaded Mode