|
Re: pic: Lexan + Heatgun =
I've done a similar thing to the edges of my model train layout to protect the rolling stock in case of a derailment so it doesn't end up on the floor. I used 1/4" Lexan and heated it with a heat gun to match the contour of the edge of the layout. I have a variable temp (200-1200 degree) Milwaukee heat gun. I started at a lower heat and held it about 6" from the piece and slowly tried to bent it. I'm guessing I bent it around 350 degrees with the heat gun several inches from the Lexan. The amount you hold the heat gun over the piece will depend on the thickness of the material, the temp you're got it set at, and how far away you are from the piece. It's best to try it on a scrap piece first. Just remember some plastics are combustable.
__________________
2006 Maryland Delphi "Driving Tomorrow's Technology" award
2006 Connecticut General Motor's Industrial Design award
2005 Finalists-----------New Jersey (along with our alliances again, 56 & 303)
2005 WINNERS of the Radio Shack Innovation in Control Award (not once, but twice! )
2004 WINNERS ------ Johnson & Johnson Mid-Atlantic Regional (also thanks to our alliances 56 & 303)
2004 General Motors Industrial Design Award Winners
2004 Archimedes Quarterfinalists (also thanks to our alliances 121 & 386)
NEMO _________ NonEngineering Mentor Organization
"Make it idiot proof and someone will make a better idiot!" - author unknown
|