|
|
|
 Of course this should be your decision- not the FIRST community's. Take charge of your destiny. - Wayne C. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Of course this should be your decision- not the FIRST community's. Take charge of your destiny. - Wayne C. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Turning Trouble!
Our robot is having a really hard time making simple turns. What is happening is that for about 30 seconds it will work fine, but then it starts making jerky turns. Basicly it starts and stops the turn even when the sticks are in the full turn position. Its almost like it has a mind of it own on turns, we dont have this trouble going forward though! Im really lost at this point any help would be great.
We are using the Cim's as motors and have a 27:1 reduction with 4WD. Dan B 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone else having trouble keeping up with work? | D. Gregory | General Forum | 36 | 28-03-2004 16:55 |
| 4-wheel drive trouble | Guilherme | Technical Discussion | 28 | 20-02-2004 14:16 |
| Balance while turning? | sanddrag | Dean Kamen's Inventions | 8 | 26-09-2003 17:18 |
| Having trouble accessing FIRST's site... | archiver | 2000 | 1 | 23-06-2002 22:24 |
| New Haven ball trouble | Jeff Rodriguez | Regional Competitions | 1 | 04-04-2002 21:47 |
Threaded Mode