|
|
|
 I like drifting, but I have to go WRC. Putting a car where it doesn't belong feels right, like combining together drill motors and power window motors and putting them on a big patch of carpet.
- Billfred [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Calculating Pneumatic Force
I know we all already shipped our bots out, but I'm curious about something. How would one go about calculating the force that one actuater can exert? I need to figure out how much force the largest actuater that Bimba offers, and how much force the original (the actuater that comes with the kit) can put out. I believe that the largest (2" bore, 24" stroke) retracts with a pressure of about 150-170 pounds at 55 psi. What is the actuater that came with the kit though? I don't know it's measurements, so I can't really approximate it.
Thanks for your help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for a force sensor | Andrew | Kit & Additional Hardware | 1 | 17-01-2004 17:54 |
| UpForce | Guyute | Technical Discussion | 18 | 14-01-2004 23:09 |
| Gearbox | Lord Nerdlinger | Motors | 20 | 15-07-2003 00:38 |
| Lots of Wheels and F = u x N | archiver | 2001 | 17 | 23-06-2002 23:37 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |
Threaded Mode