|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||
|
|||
|
Re: Carnegie Mellon Encoder
We got ours to work. Here is what we used. We used the EE-SX1061 like above but connected it in this manner to get the needed voltages.
Pin E: RC Sig Pin C: +5 Volt RC Pin K: Blk (Ground) Pin A: Either connect C to A through a 100 Ohm resistor or through a 100 Ohm resistor from a +5V RC |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carnegie Mellon Robot Hall of Fame Inductees | Aidan F. Browne | General Forum | 1 | 10-11-2003 20:45 |