|
|
|
 If you have to build the best robot to be inspired then we end up with one winning inspired team, and 999 losers. That is not the spirit of FIRST. - KenWittlief [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you have to build the best robot to be inspired then we end up with one winning inspired team, and 999 losers. That is not the spirit of FIRST. - KenWittlief [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
29-02-2004, 21:33
|
||||||
|
||||||
|
Re: How hard is it to CNC this?
Quote:
this is incorrect....if you have the clearance past the spaceing going past it with a standered cutting mill bit will leave a square notch...the side profile on a round mill while spinning is a rectangle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why was stacking so hard? | Tton | General Forum | 39 | 16-03-2003 19:17 |
| Potential Hard Drive on RC? | Goya | Programming | 10 | 09-01-2003 13:55 |
| Super Hard TV/Movie Test | Aaron Lussier | Chit-Chat | 8 | 13-12-2002 06:40 |
| Are you hard core or not? | Joe Johnson | Championship Event | 7 | 25-04-2002 23:05 |
| How hard is it to pull a goal? | Ken Leung | General Forum | 19 | 17-01-2002 20:09 |
Threaded Mode