How hard is it to CNC this?

Everyone better enjoy the broadcast, Dave had to cancel a shuttle launch to make it happen :D - The Lucas [more]

		Chief Delphi > Technical > Technical Discussion
How hard is it to CNC this?

Thread Tools

Rate Thread

Display Modes

29-02-2004, 21:43

sanddrag

On to my 16th year in FRC

FRC #0696 (Circuit Breakers)

Team Role: Teacher

Join Date: Jul 2002

Rookie Year: 2002

Location: Glendale, CA

Posts: 8,514

Re: How hard is it to CNC this?

Would I face it to length, step down the diameter, and bore the (5/8 di) hole on a manual lathe first?

__________________
Teacher/Engineer/Machinist - Team 696 Circuit Breakers, 2011 - Present
Mentor/Engineer/Machinist, Team 968 RAWC, 2007-2010
Technical Mentor, Team 696 Circuit Breakers, 2005-2007
Student Mechanical Leader and Driver, Team 696 Circuit Breakers, 2002-2004

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Why was stacking so hard?	Tton	General Forum	39	16-03-2003 19:17
Potential Hard Drive on RC?	Goya	Programming	10	09-01-2003 13:55
Super Hard TV/Movie Test	Aaron Lussier	Chit-Chat	8	13-12-2002 06:40
Are you hard core or not?	Joe Johnson	Championship Event	7	25-04-2002 23:05
How hard is it to pull a goal?	Ken Leung	General Forum	19	17-01-2002 20:09

All times are GMT -5. The time now is 16:08.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.