Operator Interface LED Drivers

[Andrew]

Has anyone programmed the OI LED drivers in the new RC?

In the old OI/RC combo, the LED drivers were tied to outputs 12, 13, 14, and 15. Despite the documentation saying that pwm1_red, etc. are the output drivers, those drivers are only tied to the blinking lights on the OI itself and do not drive the four drivers available on ports 2 & 4.

If anyone has figured this out for the new RC, I would appreciate knowing what variable connects to these drivers.

[dez250]

Originally Posted by Andrew

Has anyone programmed the OI LED drivers in the new RC?

In the old OI/RC combo, the LED drivers were tied to outputs 12, 13, 14, and 15. Despite the documentation saying that pwm1_red, etc. are the output drivers, those drivers are only tied to the blinking lights on the OI itself and do not drive the four drivers available on ports 2 & 4.

If anyone has figured this out for the new RC, I would appreciate knowing what variable connects to these drivers.

from page 10 of the 2004 rc manual from ifi;

In general, the user cannot control the team color, because it is set by the Arena Controller during competition.

Also i saw it somewheres else saying its not allowable to controll the flash rate or color of the led displays.

[The Lucas]

Originally Posted by Andrew

Despite the documentation saying that pwm1_red, etc. are the output drivers, those drivers are only tied to the blinking lights on the OI itself and do not drive the four drivers available on ports 2 & 4.

The documentation says that the LED drivers are on pins 15, 8, 9, and 5 of Ports 1 & 3 (not 2 & 4). I use them and they work (LEDs on these pins mimic the lights on the OI). [EDIT] Just set the corresponding variables mentioned in the document to 1 or 0. [/EDIT]

[Joe Ross]

Dez, he is refering to the LEDs on the Operator Interface, which are completely seperate from the team color LEDs on the Robot controller that you refered to.

[Ryan M.]

Yes, they are very easy to use. As was stated early, to turn on, set the one you want to 1 and to turn off set it to 0.

[mattf]

they are indeed very easy to use; however, there is a bug in the documentation. the led's mimic the relay lights, so use Relay1_green, Relay2_red, etc.

[Ryan M.]

Originally Posted by mattf

they are indeed very easy to use; however, there is a bug in the documentation. the led's mimic the relay lights, so use Relay1_green, Relay2_red, etc.

If you are refering to the fact that it says the PWMs, they do both. Port 3's pins are controlled by the RelayX_green etc. while port 1's pins are controlled by the pwm LED names (don't remeber them right now. )

[Astronouth7303]

I use the default code doc because it's got tables for each port. I believe they are the same as the LEDs on the OI itself.