|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
||||||
|
||||||
|
Re: How do you do basic layouts/designs
I used Inventor to do low resolution sketches for the initial design. So C-channels get modeled as square bars, motors might be just a cylinder slightly larger than actual size etc. The key here is to use the parameters to figure out the relative size of things then go back and do all of the detailed nuts and bolts.
I've started learning ProE, because we can get enough copies so everyone on the team can have one. Eventually we want to do everything in ProE. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Visual Basic | dddriveman | Programming | 12 | 20-03-2004 13:03 |
| Impending BASIC Stamp Editor Beta 2 release | Greg Ross | Programming | 9 | 19-09-2003 06:05 |
| Help programming in Visual Basic | xxlshortys | Programming | 0 | 06-04-2003 08:54 |
| Basic Run Error | BBFIRSTCHICK | Programming | 10 | 02-04-2003 22:43 |
| Manchester Rgnl. ETREMELY basic scouting DB | Rick | Regional Competitions | 9 | 24-02-2003 19:07 |