|
|
|
 The best teams have students who genuinely enjoy scouting and the alliance selection process. - Jay O'Donnell [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The best teams have students who genuinely enjoy scouting and the alliance selection process. - Jay O'Donnell [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
ADXRS300EB Rate Gyro
Hi,
I am now the proud owner of an ADXRS300EB and I want to hook this beauty up to the lego mindstorms sensor port. I already own the following interface connector: http://www.techno-stuff.com/3wire.htm so I think it should be pretty easy. I was thinking about connecting it following way: AGND to Ground AVCC to +5V Rate Out to Signal would this cause any problems? The interface produces about 6mA which should? be enough to drive the sensor. Am I correct? I dont want to damage the sensor since it is a bit expensive... Any help is much appreciated. I really need to get this going, but I am not too electronic savy  Cheers, Ram |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ADXRS150 gyro yaw rate sensor | Brian M. | Electrical | 13 | 17-10-2004 02:28 |
| Wierd gyro code problems...pls help | Salik Syed | Programming | 4 | 14-03-2004 01:29 |
| gyro code | odin892 | Programming | 2 | 08-04-2003 14:50 |
| Have YOU used the gyro chip? | FotoPlasma | Technical Discussion | 10 | 31-01-2002 13:26 |
| Yaw rate sensor (gyro for the layperson) | Kris Verdeyen | Rules/Strategy | 4 | 14-01-2002 00:41 |
Threaded Mode