|
|
|
 It will really be different for us (ESPECIALLY since our robot drives consistently this year). - Karibou [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| It will really be different for us (ESPECIALLY since our robot drives consistently this year). - Karibou [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Need Inventor model 3/4" Bore Cylinder Quick
I need a good Inventor model of a 3/4" bore cylinder with rod. I would make it myself but I don't have a cylinder here with me. I would really like to get a model soon because I have been working on a shifting transmission for the last week and now it is done down to the finest detail except for that cylinder. Thanks.
Note: the one on www.firstcadlibrary.com is not detailed enough, it doesn't have the threads and flats on the end of the rod. |
|
#2
05-04-2004, 00:40
|
|||||
|
|||||
|
Re: Need Inventor model 3/4" Bore Cylinder Quick
Check out Bimba's website. They dont have a .iam model, but they do have the .iges one, which should work for your purpose.
Cory |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mulit-postioning with pnuematics this year? | KenWittlief | Pneumatics | 101 | 01-02-2005 21:54 |
| Stopping a Piston... | Dan 550 | Technical Discussion | 7 | 02-02-2002 11:36 |
Linear Mode
