|
|
|
 I'm going to go out on a limb and say that we have to displace objects and/or robots in order to score points. - pfreivald [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm going to go out on a limb and say that we have to displace objects and/or robots in order to score points. - pfreivald [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Atwood Speed help
I知 planning on using an Atwood in an Inventor model that I知 doing for my engineering class and I came across a question; The spec sheets have "Normal load" in the performance chart, but what is normal load? is it weight specifically for this motor, or is there a standard load, say 150 lbs the motors are tested on? Any help would be greatly appreciated. If it matters, I知 trying to figure out the RPMs under different loads to calculate how fast it can move.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Joining 2 dif. motors | K.Shaw | Motors | 32 | 14-10-2004 19:40 |
| PID control loops - closed loop feedback | KenWittlief | Technical Discussion | 56 | 26-04-2004 21:27 |
| Limit of the atwood motors? | Clanat | Motors | 6 | 16-03-2004 10:46 |
| Power, speed, and torque... AGH | Gui Cavalcanti | Technical Discussion | 5 | 10-11-2002 19:02 |
| Speed of Atwood motors in forward and reverse... | Dan 550 | Motors | 14 | 04-02-2002 19:55 |
Threaded Mode