|
|
|
 My friend Noah said he talked to someone that knew me from Chiefdelphi. That's just creepy. - Adam Y. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| My friend Noah said he talked to someone that knew me from Chiefdelphi. That's just creepy. - Adam Y. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
09-04-2004, 22:25
|
|||||
|
|||||
|
Re: Using an FRC with the RCX?
The TTL port uses the same transmission format as RS-232 (low start bit, 8 data bits, high stop bit). So if you take a 3-pin cable and attach it the Tx, Rx, and Gnd pins on a DB9 female connector, you can use TTL port instead of the prog port. The macro would need to be changed slightly.
Odd, ifi_utilities.c and printf_lib.c both use 'TXREG', but ifi_picdefs.h defines 'TXREG1' and 'TXREG2'. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FRC Program State Frozen at Power-up | WillyC | Control System | 4 | 14-02-2004 18:05 |
| Request for FLL Volunteers for FLL National Invitational at the FRC Championships | Natchez | General Forum | 3 | 08-04-2003 12:19 |
| Controlling a FIRST robot with a Lego RCX Controller? | archiver | 2001 | 5 | 24-06-2002 04:19 |
Threaded Mode