|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: inventor help
I'm not sure what exactly you're describing. do you mean the center point of the circle jumps? If so, you can easily fix this by dimensioning the distance between it and the edges of a part, or other features on your drawing. I'm not at home now, so I don't have inventor, but I can help walk you through it a little bit later, if that'd help.
Good luck, Cory |
|
#2
|
|||
|
|||
|
Re: inventor help
I don't quite understand your problem either but this may be what you need. Go to Tools>Application Options Under the Sketch tab, click the checkbox that says "Snap to grid"
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|