Quote:
|
Originally Posted by sanddrag
Also, on turning long stuff, I will be needing to do a slight bit of work on the pipe. I need to turn about 1 inch of one end from the 1.660 to 1.615 and cut like a 1/8 or 3/16 slot down the side. What would be the best way to do each of these operations? Again, the pipe will be a little over 2 feet long.
Thanks.
|
Turning this could be a little tricky. My lathe at home will not allow a 1-1/4" diameter piece thru the head stock so I wouls have to turn it on centers. You will have to make plugs for the end of the pipe to provide support for the dead/live centers.
Sometimes it's not what you know going into a battle, but who you know. - Elgin Clock [more] 
Similar Threads
Hybrid Mode
