|
|
|
 "So Ken Patton, Paul Copioli, and John V-Neun walk into a bar..." - JVN [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| "So Ken Patton, Paul Copioli, and John V-Neun walk into a bar..." - JVN [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
HEX CRAWLER...
hey... i am currently working on a hex crawler bot with two other team members... which is about a feet and a half by a ft. and about half a ft. high... using 12 servos... the hexcrawler kit i got was from PARALLEX... for some reason when we turned it on... one of the servo started smoking... we opened up the servo and the board inside was fried... we are guessing that too much voltage was supplied to the servo... can anyone else come up with some other reason for the servo (board) getting fried...?
|
|
#2
28-04-2004, 21:25
|
||||
|
||||
|
Re: HEX CRAWLER...
It could have been defective to begin with. I would also guess it could have been bound up internally or externally when it tried to move. I've never taken one apart so I really don't know exactly what's inside one or how many components/pieces are in there.
|
|
#3
30-04-2004, 23:17
|
|||||
|
|||||
|
Re: HEX CRAWLER...
have anybody ever worked on this hex crawler .... its called "Parallex Hex Crawler"... www.parallex.com ... i need the code and if possible a picture of the breadboard diagram... thanks...
|
|
#4
01-05-2004, 00:12
|
|||
|
|||
|
Re: HEX CRAWLER...
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Securing hex shaft to drill output | D. Gregory | Technical Discussion | 6 | 24-01-2003 14:05 |
| Programming | archiver | 2001 | 10 | 23-06-2002 23:01 |
| Gear Making Information | Alan Ing | Technical Discussion | 14 | 29-10-2001 21:08 |
| BinHex in Pbasic | Dan 550 | Programming | 3 | 21-10-2001 20:15 |
)
Linear Mode
