|
|
|
 Robot: Aww, the FMS doesn't want to chat with me anymore. Was it something I said? - EricVanWyk [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Robot: Aww, the FMS doesn't want to chat with me anymore. Was it something I said? - EricVanWyk [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
A Quick Question
I'm doing a school project with robotics...and am programming my robot right now with one of the old PBASIC controllers and operator interfaces. The problem I have is that I'm not sure what port on the old operator interface is used to import the program. None are speciffically labeled. Is it the Radio, or Dashboard (the only 2 it could be)....I'm assuming it's dashboard.
Well...I seem to be getting some response from the dashboard...but now I'm having trouble figuring out how to get the programmer into the operator interface. I'm just using the edu robot base code...and the Stamp Editor program. If anyone could IM me, or post on how I can do this...that would be appreciated. --I'm using the old edu robot controller.....before anyone makes any comments to that effect. Last edited by Ryan F. : 05-05-2004 at 17:13. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quick question, probably asked a thousand times... | Sparks333 | Electrical | 23 | 13-12-2004 20:08 |
| A quick IR sensor question | PBoss | Programming | 7 | 28-03-2004 21:02 |
| Quick question about the ramp | archiver | 2001 | 5 | 23-06-2002 22:45 |
| a quick question | mike pawlak | Championship Event | 6 | 02-05-2002 21:15 |
| A quick question | Joelster | Technical Discussion | 6 | 10-02-2002 09:09 |
Threaded Mode