Maximum Depth of Cuts - Chief Delphi

07-05-2004, 13:51

indieFan

RoboDox and LVHS - Missing you!

FRC #5941

Team Role: Engineer

Join Date: Jan 2002

Rookie Year: 2001

Location: Seattle (was SoCal, then SA,TX))

Posts: 382

Re: Maximum Depth of Cuts

Wait, I may have terminology screwed up. I thought DOC referred to either the depth that the end of a tool sank into a material OR the amount that a tool removed on its side. If not, is the latter referring the the Material Removal Rate (MRR)?

Regardless, I'm looking at how to figure out how much material can be removed using the side of the tool.

indieFan

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Maximum amount of stored energy?	pryoplasm	Technical Discussion	1	19-01-2004 20:57
the size of the shipping crate, the maximum dimensions??????????	MASherry	General Forum	5	13-01-2004 22:30
To Maximum Oz and Two Train	Joe Matt	Thanks and/or Congrats	1	09-03-2003 13:03
maximum length of joystick cables	archiver	2001	2	23-06-2002 23:54

All times are GMT -5. The time now is 02:29.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.