|
|
|
 With any dollar amount to invest I would be more interested in the number of individuals (students is too narrow) impacted than the number of teams created--after all, this is about people. - kramarczyk [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
26-03-2002, 11:07
|
||||||
|
||||||
|
Wheel to Shaft
SilverStar,
I am assuming the whell is either for a drive wheel or a ball shooter wheel. In either case, a 1/2" trantorque may do the trick. Go to this website: www.fennerdrives.com The Torque rating for 1/2" TranTorque is 350 in-lbs (~40 N-m) The Chiaphua motor with an 18:1 gear ratio is about 40 N-m of output with no safety factor. Hope this helps. -Paul |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Who used wheel encoders | CyberWolf_22 | Technical Discussion | 12 | 04-05-2003 15:37 |
| Can you stop a pneumatic pump at half shaft | mjt902 | Pneumatics | 16 | 06-02-2003 11:58 |
| Motor coupling | archiver | 2001 | 19 | 23-06-2002 23:35 |
| shaft drive | Joseph F | Technical Discussion | 5 | 03-02-2002 17:51 |
| wheel drive | Greg Needel | Technical Discussion | 3 | 29-01-2002 12:12 |
Threaded Mode