How do you attach a wheel to a shaft?

26-03-2002, 18:27

Guest

Posts: n/a

Re: Wheel to Shaft

Quote:

Originally posted by Paul Copioli
SilverStar,

I am assuming the whell is either for a drive wheel or a ball shooter wheel. In either case, a 1/2" trantorque may do the trick. Go to this website: www.fennerdrives.com

The Torque rating for 1/2" TranTorque is 350 in-lbs (~40 N-m)

The Chiaphua motor with an 18:1 gear ratio is about 40 N-m of output with no safety factor.

Hope this helps.

-Paul

I'll try that...

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Who used wheel encoders	CyberWolf_22	Technical Discussion	12	04-05-2003 15:37
Can you stop a pneumatic pump at half shaft	mjt902	Pneumatics	16	06-02-2003 11:58
Motor coupling	archiver	2001	19	23-06-2002 23:35
shaft drive	Joseph F	Technical Discussion	5	03-02-2002 17:51
wheel drive	Greg Needel	Technical Discussion	3	29-01-2002 12:12

All times are GMT -5. The time now is 05:59.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.