|
|
|
 "I need the adjustable hammer"
"You mean that wren-"
"No, it's a hammer" - Karibou [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| "I need the adjustable hammer"
"You mean that wren-"
"No, it's a hammer" - Karibou [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Spring Compression in Inventor 6?
Does anyone know if it is possible to make a spring expand and compress when using driving constraints? I'm trying to show that the spring is attached to two different surfaces, and when they move, so does the spring. The spring was made using a coil, and I know that in the part file it assigns a parameter value for the height (which is what would be changed) but i'm not sure how to access that parameter in a sub assembly. Any help would be great.
|
|
#2
23-05-2004, 13:44
|
||||
|
||||
|
Re: Spring Compression in Inventor 6?
If it can be done, i'm guessing you need to make that feature adaptive, and make the part adaptive in the assembly. I don't have access to inventor right now so that's all the help I can give. Hope you figure it out!!
 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEW Spring Off Season in NJ | Wayne C. | Off-Season Events | 25 | 11-06-2004 10:21 |
| Compression Crisis | reisser | 3D Animation and Competition | 9 | 22-02-2004 11:23 |
| Legality of Spring Loaded Pistons | Yan Wang | Pneumatics | 13 | 19-02-2004 17:20 |
| Bosch Drill Motor Clutch Spring Dimensions?? | aaronbr28040 | Motors | 3 | 18-02-2004 19:52 |
| Grey Hindge spring loaded | archiver | 2000 | 0 | 23-06-2002 23:10 |
Linear Mode
