|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Spring Compression in Inventor 6?
If it can be done, i'm guessing you need to make that feature adaptive, and make the part adaptive in the assembly. I don't have access to inventor right now so that's all the help I can give. Hope you figure it out!!
![]() |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEW Spring Off Season in NJ | Wayne C. | Off-Season Events | 25 | 11-06-2004 10:21 |
| Compression Crisis | reisser | 3D Animation and Competition | 9 | 22-02-2004 11:23 |
| Legality of Spring Loaded Pistons | Yan Wang | Pneumatics | 13 | 19-02-2004 17:20 |
| Bosch Drill Motor Clutch Spring Dimensions?? | aaronbr28040 | Motors | 3 | 18-02-2004 19:52 |
| Grey Hindge spring loaded | archiver | 2000 | 0 | 23-06-2002 23:10 |