G-Codes vs. CAM / CNC Forums

Dave Lavery just responded to one of my posts. I think that I might die. - Karibou [more]

		Chief Delphi > Technical > Technical Discussion
G-Codes vs. CAM / CNC Forums

Thread Tools

Rate Thread

Display Modes

08-06-2004, 05:00

Avarik

Registered User

#0022

Join Date: Jan 2004

Location: Chatsworth, CA

Posts: 75

Avarik is an unknown quantity at this point

Re: G-Codes vs. CAM / CNC Forums

We usually use Gibbs CAM through our CNC, and it works really well. We usually go into a CAD program and draw the part out, then export it to Gibbs. From there, we tell it where to cut, drill, counter, etc. and set the operations up. Then its a mater of a post, and hitting that green button!

We have run into a few problems here and there, but nothing serious and nothing that wasn't our fault! Its easy to use, effective, and quick.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FIRST Forums	Andy Baker	General Forum	0	03-06-2004 18:36
To CNC? Or not to CNC?	phrontist	General Forum	21	26-03-2004 13:45
ChiefDelphi Forums Community Bulletin	Brandon Martus	CD Forum Support	0	13-08-2001 08:20
ChiefDelphi Forums Community Bulletin	Brandon Martus	CD Forum Support	0	06-08-2001 10:32
ChiefDelphi Forums Community Bulletin	Brandon Martus	CD Forum Support	0	23-07-2001 08:29

All times are GMT -5. The time now is 02:28.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.