Competition Port

[Dave Flowerday]

Originally Posted by Tristan Lall

The pinout is the same--but the autonomous-specific things are considered reserved (no connection) instead.

It's been a while since we tried it, but I'm nearly certain that pre-2003 OIs would actually accept the autonomous switch, and even send the autonomous signal to the robot (i.e. you can use 2002's OI to control a 2003 robot, with autonomous and everything). The only difference is that you won't see the rapid flashing of the disabled LED that indicates autonomous mode on 2003's OI.

[Tristan Lall]

Originally Posted by Dave Flowerday

It's been a while since we tried it, but I'm nearly certain that pre-2003 OIs would actually accept the autonomous switch, and even send the autonomous signal to the robot (i.e. you can use 2002's OI to control a 2003 robot, with autonomous and everything). The only difference is that you won't see the rapid flashing of the disabled LED that indicates autonomous mode on 2003's OI.

I thought that a 2002 model needed a firmware update to support autonomous mode. Weren't the 2002s physically identical to the 2003s, but needed to be sent back to IFI for reprogramming if you wanted to do autonomous (introduced in 2003)?

[Mark McLeod]

Originally Posted by Tristan Lall

I thought that a 2002 model needed a firmware update to support autonomous mode. Weren't the 2002s physically identical to the 2003s, but needed to be sent back to IFI for reprogramming if you wanted to do autonomous (introduced in 2003)?

I remember the firmware update to the '02 version wasn't necessary for passing the autonomous bit itself. That was just one of the "growth" bits IFI already had reserved for future use and was already passed but not used for anything in '02. I believe what the firmware update changed was to actually cut off access to the OI inputs while the autonomous bit was set, e.g., the Joystick values were all forced to 127, etc.
You might have to take into account that the OI control values will still be passed, for instance, by explicitly setting the OI inputs to neutral values at the beginning of your autonomous section of code. Then again your autonomous code probably will be ignoring those values anyway.

[Joe Ross]

Pin 1 on the competition port is hooked directly to +5 on the OI.
However doing so will void your warranty. Pin 8 is ground.

[roboticsguy1988]

Ok, thank you. I have the disable switch working, and i am going to probably hook up the LEDs later.

Thanks,
Larry

[dez250]

Originally Posted by roboticsguy1988

Ok, thank you. I have the disable switch working, and i am going to probably hook up the LEDs later.

Thanks,
Larry

I still would suggest you make an led circuit run off of a 9 volt battery. If you do run the leds off of pins on the oi's comp port and any damage done in the future or and work you would like done to that oi, including upgrading firmware can be rejected by ifi even if your paying for it due to you fooling with the pins. Your choice should be thought about before you play with "fire" by running leds off of the comp port.