|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: White Paper Discuss: Team 716, 2004 Dual Speed Gearbox
Quote:
|
|
#2
|
|||||
|
|||||
|
Re: White Paper Discuss: Team 716, 2004 Dual Speed Gearbox
Quote:
Just use a piece of aluminum angle, and the mill out the profile on the drawings. Cory |
|
#3
|
|||||
|
|||||
|
Re: White Paper Discuss: Team 716, 2004 Dual Speed Gearbox
Quote:
![]() |
|
#4
|
||||
|
||||
|
Re: White Paper Discuss: Team 716, 2004 Dual Speed Gearbox
The angle pieces were made from 2x2x1/4 aluminum angle.
For a good reference to shapes and metals go to http://www.mcmaster.com/ and type in 'aluminum' for the search. Select aluminum and you will find a reference page for shapes and the different alloys available. |
|
#5
|
||||
|
||||
|
Re: White Paper Discuss: Team 716, 2004 Dual Speed Gearbox
Yes, 2.28 is the length you would machine the angle to.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: Continuing the Cycle: A Guide to Starting a University-Supported FIRST Team | CD47-Bot | Extra Discussion | 2 | 15-05-2006 14:58 |
| Robot Collaboration | Karthik | General Forum | 153 | 18-02-2004 03:40 |
| White Paper Discuss: Team 159 3.0 | CD47-Bot | Extra Discussion | 2 | 24-06-2003 17:18 |
| The 2003 Index of team's post about their robot... | Ken Leung | Robot Showcase | 4 | 28-02-2003 00:18 |