|
|
|
 Wow, an entire thread with positive comments. I must be on the wrong forum... but my URL still says chiefdelphi.com. Hmmmm... - Chris Hibner [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Wow, an entire thread with positive comments. I must be on the wrong forum... but my URL still says chiefdelphi.com. Hmmmm... - Chris Hibner [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
13-08-2004, 18:01
|
||||
|
||||
|
Re: A good, CHEAP PC for Autocad
As everyone has been saying, don't go too cheap on the RAM, especially if you go with a P4 or P3. I currently have 640 MB in mine, and Inventor 7 Pro works just fine. A gig would be nicer but 512 wouldn't give you any serious problems. Just don't make the mistake that I did and get one with less than 512, or you will be VERY frustrated.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2004 1st (Annual?) Beantown Blitz - The Good, The Bad, and The Ugly. | Elgin Clock | Off-Season Events | 24 | 27-05-2004 14:44 |
| Congrats all and good luck on Saturday(Tomorrow) | CrimsonDesigns | Championship Event | 0 | 16-04-2004 16:48 |
| Dean would make a good Donald! | Jessica Boucher | Televised Robotics | 1 | 13-04-2004 10:42 |
| IT to be revealed on Good Morning America | Joe Ross | Dean Kamen's Inventions | 50 | 13-12-2001 09:53 |
Threaded Mode