|
|
|
 I shouldn't be doing a happy dance or anything, should I? - Qbranch [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I shouldn't be doing a happy dance or anything, should I? - Qbranch [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
[OCCRA]:a few questions..
We have a couple of questions.
Does the 9 tooth sprocket on the drill motor count against the 18 that we are allowed to have on the robot? The rules say there are 5 sprockets sizes to choose from in the Kit of materials but this size is not listed. We just need a clarification on that one. Are the quantity numbers in the kit of parts for the two different keyangs motors correct? We thought we overheard that you were allowed 4 with the integral shaft and 2 with the square hole in it. Was this a change from couple of years ago or were we just hearing things? Thanks for any help on this matter. Team RUSH 27 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unanswerable Questions!! | Devin L. | Chit-Chat | 52 | 04-08-2004 22:19 |
| 3 Questions!!! (2/20/04) | Andy Grady | General Forum | 20 | 20-02-2004 17:31 |
| 3 Questions!!! (2/5/04) | Andy Grady | General Forum | 11 | 05-02-2004 21:14 |
| 3 Questions!!! (1/5/04) | Andy Grady | General Forum | 8 | 05-01-2004 16:01 |
| $3500 limit - Who does not have questions | Raul | Rules/Strategy | 5 | 12-01-2003 11:31 |
Threaded Mode