|
|
|
 We're thinking of using static electricity to pick up the tubes. The programmers are trying to figure out how to make the robot shuffle it's feet on the carpet. - Tom Ore [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
[OCCRA]: hose clamps on drill transmissions' gear selector?
previous years' drill transmissions' gear selector tended to pop into "neutral" during matches so we clamped them in either gear with hose clamps... do you recommend doing so this year too? if yes, how? the gear selector is 90 degrees off from last year.. and also 3 gears...
Last edited by greencactus3 : 05-10-2004 at 22:31. Reason: clarify 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: drill transmission | greencactus3 | OCCRA | 4 | 14-10-2004 22:33 |
| Coupling the drill motor with out the 15 tooth gear | Chopper_Dave | Motors | 1 | 17-01-2004 01:06 |
| Info on gear on drill motor | archiver | 2000 | 2 | 23-06-2002 22:58 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| drill motor transmissions | nwagers | Motors | 16 | 29-01-2002 10:54 |
Threaded Mode