|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||||
|
|||||
|
Re: chains
#25 ANSI chain has a working load of 140lbs
#35 ANSI chain is 480lbs then next after that is #40 at 810lbs So you get a significant increase in strength going from #25 to #35 I think it's possible with some FIRST bot setups to take #25 past yield or at least well into the built in safety factor whatever that may be But I can't see harming the #35 with a strong drive train under some shock loads. I think #40 is just overkill and too much weight. FIRST provided #35 chain in our kit last year, I think it was 20'. along with some #35 sprockets. So it's not a bad idea to stick with #35 just in case you want to use them. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chain Drive Question | Matt_Kaplan1902 | Technical Discussion | 34 | 12-04-2004 14:21 |
| "Automatic Transmission" | Madison | Technical Discussion | 70 | 24-11-2003 09:03 |
| 967 visualization | tinsLee123 | 3D Animation and Competition | 9 | 12-05-2003 15:22 |
| chains in 3ds | tinsLee123 | 3D Animation and Competition | 4 | 17-02-2003 00:14 |
| chains | enjoiwheels | Inventor | 0 | 08-02-2003 19:33 |