Receiver to control unit connection

sanddrag · #1 26-10-2004, 13:21

Perhaps this PDF will be of some benefit.

Bob16 · #2 27-10-2004, 08:41

We are using a three wire connector and we need to go from a 8 channel receiver to the control unit. I just need to know which R/C PWM IN to hook into from channels 2 and 3 on are reciever.

Mark McLeod · #3 27-10-2004, 09:20

Quote:

Originally Posted by Bob16

We are using a three wire connector and we need to go from a 8 channel receiver to the control unit. I just need to know which R/C PWM IN to hook into from channels 2 and 3 on are reciever.

See page 6 of the PDF Sanddrag posted.
You should also look at the 2004 EDU Default Software Reference Guide to see what each of the controls will do. The documents you need are on the IFI website http://innovationfirst.com/FIRSTRobo...umentation.htm

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PID control loops - closed loop feedback	KenWittlief	Technical Discussion	56	26-04-2004 21:27
What do you wish you knew about the new control system?	Joe Ross	Control System	2	09-01-2004 21:47
How to connect the R/C receiver?!	Tim Skloss	Robotics Education and Curriculum	7	10-12-2003 16:34
more control options	smokescreen	Technical Discussion	17	05-03-2002 15:41
goals: how much control?	Pat Sarmiento	Rules/Strategy	2	18-01-2002 19:10