|
|
|
 If you are adult enough to be a participant in this program, then you are adult enough to act like an adult. - Beth Sweet [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you are adult enough to be a participant in this program, then you are adult enough to act like an adult. - Beth Sweet [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Cylinder mock-ups of gears in Inventor?
Hi, I was trying to simply use cylinders instead of actual gears in Inventor to help save some time.
What I'm asking is how do I figure out the diameter of the cylinder to draw so that the cylinders would touch where the gears would normally mesh? Would I use the pitch diameter? Or something? I kept searching around and kept getting different results and it's driving me crazy. Thanks in advance for any help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for gears from BostonGear in Inventor.. | geo | Inventor | 6 | 05-08-2004 10:07 |
| Gears in Inventor | Joshua May | Inventor | 12 | 01-07-2004 23:32 |
| Need Inventor model 3/4" Bore Cylinder Quick | sanddrag | Inventor | 1 | 05-04-2004 00:40 |
| Stopping a Piston... | Dan 550 | Technical Discussion | 7 | 02-02-2002 11:36 |
| How do i make gears in inventor? | mnkysp6353 | Inventor | 1 | 16-01-2002 02:31 |
Threaded Mode