|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Cylinder mock-ups of gears in Inventor?
Yes, the pitch diameter is what you should use. If you don't know it, it is the Diametral Pitch (the number describing the size of the teeth 20, 24, etc) divided by the number of teeth. 40 tooth 20 pitch gear has a 2" pitch diameter.
You may also want to draw the overall diameter of the gear to check for interferences. Last edited by Max Lobovsky : 01-12-2004 at 23:23. |
|
#2
|
|||
|
|||
|
Re: Cylinder mock-ups of gears in Inventor?
Quote:
20/40 = 1/2 Am I wrong? (Just trying to fix any confusion this could cause )Last edited by Tom Bottiglieri : 02-12-2004 at 15:08. |
|
#3
|
|||||
|
|||||
|
Re: Cylinder mock-ups of gears in Inventor?
Quote:
metric gears, on the other hand, use module: (# of teeth)*DP= Pitch diameter |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for gears from BostonGear in Inventor.. | geo | Inventor | 6 | 05-08-2004 10:07 |
| Gears in Inventor | Joshua May | Inventor | 12 | 01-07-2004 23:32 |
| Need Inventor model 3/4" Bore Cylinder Quick | sanddrag | Inventor | 1 | 05-04-2004 00:40 |
| Stopping a Piston... | Dan 550 | Technical Discussion | 7 | 02-02-2002 11:36 |
| How do i make gears in inventor? | mnkysp6353 | Inventor | 1 | 16-01-2002 02:31 |