|
|
|
 "Greatness isn't achieved by doing the uncommon things but instead by doing the common things uncommonly well."
- Wayne C. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "Greatness isn't achieved by doing the uncommon things but instead by doing the common things uncommonly well."
- Wayne C. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
shaft encoder help
hi, I don't know if anyone is having the same problem, but the white paper on using shaft encoders is a little above my level. if you'r Kevin Watson, is it possible you could write a tutorial or explain your code in a simplified form. this thread could be a nice place to explain it. if anyone can help that would be wonderful. any basic knowledge at all would be awesome.
Last edited by stephenthe1 : 02-12-2004 at 23:08. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Choosing an Encoder for the Drive-train | MikeDubreuil | Electrical | 11 | 21-10-2004 00:50 |
| pic: 571's new gearz loose weight | CD47-Bot | Robot Showcase | 24 | 16-04-2004 16:35 |
| Wiring "3-pin" Shaft Encoder. | Joel J | Programming | 7 | 27-02-2004 17:21 |
| how to add steps in the provided encoder program for the edu | Zaramel2002 | Programming | 3 | 11-02-2004 08:35 |
| Problem with 5/8 in. shaft in this years kit | echos | Kit & Additional Hardware | 5 | 14-01-2004 21:21 |
Threaded Mode