Recovering code from the RC

Astronouth7303 · #1 04-12-2004, 19:25

Quote:

Originally Posted by Rickertsen2

I started to think about this and got excited. Then realized it is not possible to access the necessary 4 pins from the outside. You can only access 3 out of 4 of them from the outside

SO CLOSE!!!
Just for the info the 3 are as follow:
GND- any ground anywhere on the RC will do
PGC(program clock)(RB6)- Digital I/O 5
PGD(Program data)(RB7)-Digital I/O 6
MCLR(master clear/reset)-

No hope of accesing this from the outside

Would you only need these for downloading to the PIC? or just uploading from?

Rickertsen2 · #2 04-12-2004, 20:02

Quote:

Originally Posted by Astronouth7303

Would you only need these for downloading to the PIC? or just uploading from?

Both

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What is your most prefered programming language?	Hailfire	Programming	156	19-01-2005 21:42
Sourceforge for Code Repository and other stuff	SilverStar	Programming	9	15-01-2005 21:16
heres the code. y this not working	omega	Programming	16	31-03-2004 15:18
Inserting Naviagation code into Default code?	actorindp	Programming	3	28-01-2004 18:12
Does your team use the Default code.	Jeff McCune	General Forum	2	09-01-2003 14:46