|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: Shifting Mechanism 222
Did you find it was really neccesary to use tool steel (that must have been fun to machine...) and harden it? Was there enough wear to warrant it?
|
|
#2
|
|||||
|
|||||
|
Re: pic: Shifting Mechanism 222
You could probably get by a season without hardening the shaft, but since we have not tested doing so I could not tell you what the results would be.
Here are the measurements I got from the gears; I do not have the shaft measurements for between each gear. Third Gear: 1.014'' Second Gear: 1.001'' First Gear: 1.001'' Being that we used second gear the most it had the least amount of wear because it was not able to "freewheel'' on the shaft. Overall the shaft was at 1.008'' in diameter, I am not sure of what it was when it was after being machined. ![]() |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Tigertrons 222 Memorial Day Parade | CD47-Bot | Extra Discussion | 11 | 17-06-2004 14:51 |
| pic: 222 2001-2004 robots | CD47-Bot | Extra Discussion | 16 | 20-05-2004 21:09 |
| pic: 222 3 speed closeup/cutaway | CD47-Bot | Robot Showcase | 64 | 25-04-2004 15:25 |
| pic: 222 3 speed on the robot | CD47-Bot | Robot Showcase | 6 | 11-03-2004 21:39 |
| pic: Team 60 Mechanism | CD47-Bot | Robot Showcase | 2 | 11-02-2004 21:47 |