|
|
|
 Those teams with too much pride will hinder their alliance. Know your strengths and weaknesses and be honest about them. - Andy Brockway [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Those teams with too much pride will hinder their alliance. Know your strengths and weaknesses and be honest about them. - Andy Brockway [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
08-01-2005, 20:06
|
||||
|
||||
|
Re: AutoCad Inventor in KOP?
There wasn't a specific FIRST e-mail blast about the shipping of the software because they weren't mailed ALL at one time. They were being sent as teams registered and paid for their first regional competition. Also, before calling FIRST I would recommend that you double-check all of your team's information on TIMS... especially the section on shipping contact and address. That could tell you where the package was sent to; however, if there are conflicting or missing information, they will not send you anything until you have corrected your team's data.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inventor to AutoCAD | rmmlg | Inventor | 10 | 14-12-2004 21:26 |
| Autocad error?!?! | Adam Y. | Inventor | 9 | 18-11-2004 11:04 |
| Looking for KOP Helical Gears | ChuckDickerson | Kit & Additional Hardware | 1 | 21-07-2004 15:39 |
| AutoCAD Viewer | Gadget470 | OCCRA | 2 | 25-09-2002 03:19 |
| AutoCAD, Inventor, or Other | D.J. Fluck | General Forum | 23 | 31-12-2001 08:59 |
Threaded Mode