Inventor Tetra Connector

09-01-2005, 20:17

Curt Henderson Curt Henderson is offline

Registered User

FRC #1501 (Team T.H.R.U.S.T)

Team Role: Engineer

Join Date: Mar 2002

Rookie Year: 2002

Location: Huntington, IN

Posts: 68

Send a message via Yahoo to Curt Henderson

Re: Inventor Tetra Connector

The Fold command is in the sheet metal environment.

I start the part as a sheetmetal part, created the clover leaf pattern and then created a bend lind as mentioned on the print.

When you use the Fold command you have options as to where the bend line will be oriented. I had the best success with having it at the start of the bend.

Good Luck

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can someone post this on FIRST q/a	Joe Ross	Electrical	23	16-02-2004 17:28
power connector for 2004 EDU controller	kc8nod	Robotics Education and Curriculum	6	25-11-2003 16:59
Unsafely securing Anderson connector?	Andy A.	Electrical	20	16-04-2003 22:11
90 degree robot modem connector	archiver	2001	10	24-06-2002 00:03
DB15, Male 15 pin connector.	AdamT	Technical Discussion	8	06-02-2002 17:17

All times are GMT -5. The time now is 14:48.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.